Agricultural Machinery Manufacturers, Farm Equipment Suppliers,
Agricultural Machinery Suppliers, Cultivation Machinery Suppliers / manufacturers, Tillage Machinery Suppliers / manufacturers, Horticultural Products East Africa, East Africa, Kenya, Uganda, Tanzania
Equipment Name:
Name:
Company:
Email:
Tel:
Comments:  


Enter Code
 

The Ndume GM40 Pto


Ndume GM40 Pto


Pto Driven Portable Hammer Mill


Easy Attachment: Just connect the linkage arms and the PTO shaft. No flat belt and pulley attachment on tractor required.

Full Mobility: When necessary, mill can be taken to the foodstuff in the field. No foundation and hold-down bolts required.

The Ndume GM40 PTO-driven Hammer Mill is mounted on an all-steel, heavy-duty frame. On the same frame are also mounted the cyclone and the PTO driven shaft and pulley.

The frame has three point linkage attachment pins for ease of moving the unit from place to place. Using the linkage attachment points when grinding also ensures that the PTO shaft is always properly aligned thus prolonging it's life.

The GM40 is a large capacity robust, long life, all-purpose mill capable of dealing with fodder roughage and grain of all types.

The GM40's capacity will of course vary according to:
  1. Size of screen fitted
  2. Driving horsepower available
  3. Material milled and
  4. Moisture content of material
Under normal conditions the mill will produce in excess of 10 bags per hour.  The GM40 requires low (2300-2600) RPM, which is ideally suited to the tractor drive system.

The GM40 has a large fan of special design, producing a powerful airflow.  The GM40's convenient easy feeding chute is large and with swinging baffle plates for operator safety.

The GM40's extra large cyclone is matched to the mill to guarantee clean economical trouble-free milling.  Every mill leaving the Ndume factory at Gilgil is test run, and carries a guarantee.
 
Specifications 
Speed of mill rotor
2000 - 2600RPM
 Drive  Tractor pulley, stationary engine, or electric motor
 Power requirement  25 - 100Hp
 Rotor shaft size  2" Diameter, with key way
 Bearings  Heavy duty 2" sealed flange
 Screen  Interchangeable and wide selection
 Screen area  535sq.ins.
 Grinding plate area
 300sq.ins
 Hammers
 24fixed, hardened steel
 Feed hopper  Large capacity adjustable
 Fan  Original design so as to produce a large volume of air to draw all the ground meal and leave the screen clear. Makes clean economical milling
 Cyclone, Bagging  Single or two way spouts.
   
            

  Conservation Tillage equipment, East Africa, Kenya, Tanzania

  NDUME LIMITED
Phone:      020-2186668/9, 2186671/2
Address:   PO Box 62, 20116 Gilgil, Kenya
Email:        info@ndumekenya.com
Website:   www.ndumekenya.com
  Airport handling Equipment
Chisel Ploughs
  Grain Auger 
  Cultivators
  Harrows
  Seeders and Planters
  Horticulture
 

 

  Grain Milling
  Wood Stoves and Water Heaters
  Tipping and Non Tipping Trailers
  Water- Driven Water Pumps
  Damscoops and Land Levelers
  Lawn and Field 
Copyright © 2010, All Rights Reserved Ndume Ltd.